Omron DRT2 Series Operation Manual page 135

Environment-resistive Terminals
Maintaining Enclosure
Ratings
118
XS2Z-12 Waterproof Cover
The connector will meet IP67 standards
is a Waterproof Cover is attached.
Always tighten the connector by hand to
a torque of 0.39 to 0.49 N·m.
Note 1. The IP67 enclosure rating will not be met if the surfaces where the contact
block and cover meet are subjected to excessive force. Protect the contact
block and cover from excessive force.
The IP67 standard is lower than waterproof standards. Do not submerge
the system components.
The body of the components is plastic resin. Do not place objects on the
components or allow the components to be stepped on.
2. There are two kinds of wiring for OMRON Two-wire Proximity Switches
(pre-wired with connector). One switch has IEC pin arrangement (M1GJ
type) and the other has OMRON pin arrangement (M1J type). Refer to the
following table to determine the appropriate Environment-resistive Termi-
nal to use with each kind of switch.
Two-wire Proximity Switch
(pre-wired with connector)
IEC pin arrangement (M1GJ type) DRT2-ID08C-1
OMRON pin arrangement (M1J
type)
XS2Z-15 Dust Cover
Press the Dust Cover onto the connector
firmly. The Dust Cover will protect the con-
nector from dust, but does not meet IP67
standards.
Compatible Terminal
DRT2-HD16C-1
DRT2-ID08C
DRT2-HD16C
Section 6-3