Omron DRT2 Series Operation Manual page 69

Remote I/O Terminal and Environment-resistive Terminal Functions
Setting Using the
DeviceNet
Configurator
1,2,3...
52
• Counting unit: One operation
Slave
Number of
operations
OFF→ON
Output device
(relay, etc.)
Note 1. The Contact Operation Counter and Total ON Time Monitor cannot be
used at the same time for a single contact. Select the function to be used
under the Detection Mode heading.
2. The Contact Operation Counter will operate when the I/O power is ON
only.
The method used to set values from the DeviceNet Configurator (Ver. 2.20 or
later) is described here.
1. Turn ON the power to the DRT2-series Smart Slave.
2. From the Main Window, open the Network Configuration Window and dou-
ble-click or click the right mouse button over the icon of the DRT2-series
Smart Slave to be set. Select Parameter and Edit to display the Edit De-
vice Parameters Window.
From the Maintenance Mode Window, click the right mouse button over the
icon of the DRT2-series Smart Slave to be set. Select Parameter and Edit
to display the Edit Device Parameters Window.
3. Select the IN Tab.
4. Double-click the I/O Comment field of the applicable contact to display the
following window. Select Count under Detection Mode, enter a value in the
Recorded in the Slave
I/O power
Number of times output
contact changes to ON.
Section 4-3
1 2 3