Omron DRT2 Series Operation Manual page 158

Analog Input Terminals
1,2,3... 1. Double-click the icon of the Master Unit to which I/O will be allocated and
open the Edit Device Parameters Window. (From the Maintenance Mode
Window, click the right mouse button over the Master Unit icon and select
Parameters and Edit.)
2. Click the General Tab, select the Analog Slave to be set, and click the Ad-
vanced Setup Button.
3. Click the Connection Tab, and select User Setup. Select Use Poll Con-
nection, and then select the I/O data (pattern) from the pull-down menu
for the connection path. In the same way, select Use Cyclic Connection,
and then select any I/O data (pattern) from the pull-down menu for the con-
nection path.
4. Click the OK Button and exit the window.
5. Click the I/O Allocation (IN) Tab and edit the I/O allocations.
Select the Smart Slave to be set and click the Edit Button to display the
Edit I/O Allocate Window.
Set the Poll settings (Analog Data 1 + Analog Data 2 in this example) to
block 1, allocated 3300 (word CIO 3300).
Section 7-3
141