Omron DRT2 Series Operation Manual page 50

DeviceNet Remote I/O Communications
Poll
Bit-Strobe
COS
Cyclic
output data, the IN size for poll connection is set to input data, and OUT
size for poll connection is set to output data.
3. Click the OK Button.
Note If there are checks in the checkboxes but the connection path settings are left
blank, the following settings will be made automatically.
IN (Smart Slave to Master Unit)
input data
input data
generic status
generic status
Note For Slaves with outputs (and consequently output size settings), if the poll and
COS connections are used at the same time, the output size settings for poll
and COS connections must be set to the same value. Perform this setting with
the Configurator using the method below. (The default output size setting for
the COS connection is 0.)
Click the right mouse button over the Slave to be set, select Property, click
the I/O Information Tab, and then click the Edit Button. In the Edit I/O Size
Window, set the OUT Size for the poll and COS connections to the same
value.
OUT (Master Unit to Smart Slave)
output data
Not set.
Not set.
Not set.
Section 3-2
33