Omron DRT2 Series Operation Manual page 189

Analog Output Terminals
Item
DA conversion data
Isolation method
I/O connection method
Standard accessories
Names and Functions
of Parts
Setting the Output
Signal Range
Setting with the DIP
Switch
172
Communications
connector
The output range can be set using the DIP switch or the Configurator.
1 2 3 4 5
Each pin is set according to the following table.
Pin No.
1
2
3
4
5
6
7
8
Note 1. Always use the default setting (OFF) for pin 7.
Voltage output
–10 to 10 V range: F448 to 0BB8 hex full scale (–3,000 to 3,000)
Other ranges: 0000 to 1770 hex full scale (0 to 6,000)
±
DA conversion range:
Photocoupler isolation (between output and communications lines)
No isolation between output signal wires.
Terminal-block connection
None
Rotary switches.
Set the node address.
DIP switch
DeviceNet
Sets the output
indicators
ranges.
Removeable terminal block
6 7 8
Setting
Sets output range for Output 0
Sets output range for Output 1
Always OFF.
Range setting method
Specifications
Current output
5% FS of the above data ranges.
Specifications
Default setting: All pins OFF
Default setting: All pins OFF
Always set this pin to OFF.
OFF: Use Configurator.
ON: Use DIP switch.
Default setting: OFF
Section 7-4