Omron DRT2 Series Operation Manual page 85

Connecting Communications Cables to General-purpose Slaves
Precautions
We recommend the
following crimp terminals.
The OMRON XW4Z-00C
Screwdriver for tightening
line set screws is also
available.
Supplying
Communications Power
Using T-branch Taps
68
to check that it is securely connected to the connector.
Blue
(CAN L)
Black ( − V)
There are colored stickers provided on the Master Unit and Slaves that
match the colors of the lines to be inserted. Check that the colors of the
lines and stickers match when wiring the connectors.
The colors used are as follows:
Color
Red Power line, positive voltage
(+V)
White Communications line, high
(CAN H)
- Shield
Blue Communications line, low
(CAN L)
Black Power line, negative voltage
(−V)
PHOENIX CONTACT, AI-series Crimp Terminals, AI-0.5-8WH-B (product
code 3201369)
Crimp terminal Line
Insert the line into the terminal
and then crimp.
The following crimp tool is also available.
PHOENIX CONTACT, ZA3 Crimp Tool
The end of the screwdriver has the following dimensions.
Side View Front View
0.6 mm 3.5 mm
Connect the +V and − V of the power lines to the connectors in the same way
as for communications cables. If the communications power supply is in one
location only, connect a shield to the connectors when securing them, and
Red (+V)
White
(CAN H)
Shield
Signal
Section 5-2