ZETRON 4000 Series Installation Manual page 64

Table of Contents

Advertisement

Common Control Equipment Installation
3. Configure the iRIM for LLGT.
Configuring the iRIM requires that you have a working network connection from a
maintenance PC to an installed iRIM. If you do not, see Intelligent Radio Interface
Module for Kenwood Radios (P/N 025-9520) for connection information.
a. Open a web browser, such as Internet Explorer, and connect to the iRIM. The
b. Click View or Modify Configuration.
c. Depending on the channel you need to configure, click Channel A
d. Set Audio Level To Console to -7 dBm (the default value).
e. Enable Guard Tone To Console On COR. This enables LLGT output from
4. Configure the channel with IntegratorRDPS.
a. Using IntegratorRDPS, make sure the channel is programmed as a Tone
5. Adjust and test the configuration.
a. Key up a remote radio, but do not speak. This causes the low level guard tone
b. Adjust the UDCC Rx level pot so that the Rx test point reads -44.4 dBm (4.7
6. Make some radio calls and confirm correct operation.
64
Note
Step 3 only applies to the VOX+LLGT method of detection. For
VOX+COR, skip to
default address is http://192.168.0.133/ and the default password is 8206363.
Parameters or Channel B Parameters.
the iRIM. Note there is no level setting for the LLGT; the iRIM always
generates LLGT at -18dB below the Audio Level To Console setting. This
means that the iRIM shall generate the LLGT at a level of -25dBm if the iRIM
device generates an Audio Level To Console signal at a level of -7dBm by the
default parameter level setting.
Note
Step 4 only applies to the VOX+LLGT method of detection. For
VOX+COR, skip to
channel with iRIM enabled (see
Note
Step 5 only applies to the VOX+LLGT method of detection. For
VOX+COR, skip to
to be sent.
mV rms). This is a simple way to adjust Rx audio level when using an iRIM,
the resulting Rx level should be the same as if it was adjusted using the normal
Rx adjustment procedure (40% deviation is at the knee of the AGC).
Step
6.
Step
6.
Defining the Channel
Step
6.
on page 269).
025-9533Y

Advertisement

Table of Contents
loading

Related Products for ZETRON 4000 Series

This manual is also suitable for:

41184115b40184217b4219

Table of Contents