Table of Contents
Advertisement
IntegratorRDPS Programming
Setting the Intercom Door Latch Output
This selection specifies an additional output for the intercom that is typically used to
control a door latch associated with the intercom input.
Output
When the Output option button is selected, the screen is configured as shown in
59.
Selecting the Aux Output Mode
Outputs may be either Momentary or Toggle. Momentary means that when the console
operator activates the output, it will only remain active while the operator holds down the
key. Toggle outputs toggle from active to inactive or inactive to active each time the key is
pressed.
Setting the Output Interlock Group
For toggle-type outputs, the interlock group is used to assign outputs to a group that will
allow only one output to be active at a time. If the interlock group is set to "0", no
interlock is applied. Up to 32 interlock groups may be assigned.
Figure 59: Aux Output Definition window
280
Note
If the outputs have not yet been defined, you will have to come
back to this point later to make your selection.
Figure
025-9533Y
Advertisement
Table of Contents
