Table of Contents
Advertisement
IntegratorRDPS Programming
Parameter/Area
Coded Speech Control
(Tone Cards Only)
Hook Flash
(If Phone is selected)
Base Station
Configuration
(DC or Tone cards only)
Private Line
(Tone Cards Only)
DVP Coded/Clear
(Tone cards only)
Page Settings
Repeater Control
ANI Mode
ANI Type
5/6 Tone Parameters
(If 5/6 Tone selected)
270
To use Private Line (PL), disable Coded Speech. Private lines can then be
configured.
To use Digital Voice Privacy (DVP), enable Coded Speech. Tone remote
channels can be configured to send tone remote functions to enable/disable
encryption at the base station and to send either dual- or single-function tone
sequences with a transmission.
Sets the duration of the Hook Flash generated when the Hook Flash button is
pressed for this channel.
The Base Station Configuration field allows you to define the number of
transmitter and receiver frequencies that your multi-frequency base station
supports. This field is entered in the form of TxRy, where x is the number of
transmitter frequencies and y is the number of receiver frequencies. Acceptable
values for x and y are between 1 and 16. It is not necessary that x and y be the
same. The following are examples of valid entries:
T1R1 T2R1 T4R4
To configure frequencies and functions, see
Functions
on page 271.
To use Private Line (PL), disable Coded Speech. Private lines can then be
configured.
Tone-remote channels can be configured to support control of up to eight
Private Line or Channel Guard modes. Valid numbers are 0 and 2 through 8.
To configure PL control functions, see
page 271
Allows the user to define the Digital Voice Privacy Coded and Clear
remote functions and the transmit mode.
See
Specifying the DVP Control Functions
During paging, a keyup delay can be specified that will delay the time from
keyup to the start of the page. The keyup delay is entered in milliseconds. Valid
range is 0 - 6000 ms.
Paging tones sent on channels with De-Emphasis enabled will be de-
emphasized unless they are being sent as a simulcast including at least one
channel without De-Emphasis.
Enable Repeater Control if this base station includes a repeater, otherwise
clear the box.
If repeater control is enabled, the labels to be displayed and the functions
performed must be entered when the repeater ON/OFF keys are pressed. The
first field is a 1-, 2-, or 3-character identifier that shows the repeater condition.
The second field is the tone or current signal used when the console repeater
ON/OFF keys are pressed.
There are several different formats of ANI that may be selected. The different
formats change the response of the console to receiving an ANI.
See
Selecting the ANI Mode
5/6 Tone Channel Parameters
See
Purpose
Specifying the Frequency Control
Specifying the PL Control Functions
on page 272
on page 272.
on page 272.
on
.
025-9533Y
Advertisement
Table of Contents
