Table of Contents
Advertisement
IntegratorRDPS Programming
Table 101: (Miscellaneous) System Parameters window
Parameter/Area
Priority Marker
Transmit Timeout
Emergency Alert
Audible
System Positions
Enables
Screen Size
Global Call
Management
Disable M427
Incoming Call Beeps
Trim ANI Leading
Zeros
288
A priority marker tone is issued when the Priority Marker key is pressed for a
selected channel. The priority marker entry fields specify the frequency, duration,
interval, and amplitude of the marker tone. Table 99 identifies the range limits on
each entry.
Frequency: 600 to 2000 Hz
Duration: 50 to 1000 ms
Interval: 1 to 300 seconds
Amplitude: 1 to 100 percent
The transmit timeout is the maximum amount of time a channel can be keyed
before the channel is automatically released. The default timeout period is three
minutes. You may select from "Disabled" or values between one minute and 10
minutes in one-minute intervals.
This configures what type of alert audible activated by IntegratorRD on receiving
an emergency call. If "Continuous Tone" is selected, to deactivate the alert, use the
Alarm Ack or Review ANI key.
When enabling a console position, you designate which positions are available for
position-to-position features, such as Console Intercom or Console Takeover.
Positions should be enabled for any Zetron console in your system, including both
IntegratorRD and button-based consoles.
IntegratorRD supports two screen sizes. If Chinese/Arabic language support is
selected, the screen option will be disabled and forced to 1024 x 768.
This option allows other positions to be informed when a call or alarm has been
handled by a position. When "Global Call Management" is enabled, deactivating
alarm with Alarm Ack key, reviewing an RSC mode ANI or an emergency PTT ID
mode ANI, or replying to a call from one position will be updated to all other
IntegratorRD positions.
Other positions shall also be informed when a call entry is removed from Call
History window using the Call Delete key by enabling "Include Global Call
Delete" option.
This option allows you to disable incoming call beeps on MAP27 channels
connected to an M427. Mark Yes to disable the beeps.
When IntegratorRD receives PTT-IDs for which no alias is found, it displays the
entire ID, including leading zeros. Enable this option to prevent leading zeros from
being displayed.
Purpose
025-9533Y
Advertisement
Table of Contents
