Table of Contents
Advertisement
Confirmation (MDC-1200 Commands)
Call Alert
Emergency Alert
Emergency
Acknowledge
Radio Check
Status Request
Status Update
Radio Disable*
Radio Enable*
Remote Monitor*
Disable
Remote Monitor*
Enable
* These commands can be selectively password-protected by enabling them in the
Password section.
Miscellaneous Parameters
Tip
Figure 65: (Miscellaneous) System Parameters window
Call alert is a no-voice transmission call to a particular radio ID.
Emergency alert is a radio channel declaring an emergency.
This message is sent as a response to an emergency alert to the
radio that sends the emergency.
Radio check is sent to a radio ID requesting its acknowledgement.
Status request is sent to a radio ID requesting its current status.
Status update is sent to an MDC-1200 channel to update its status.
This message is sent to a radio to disable itself.
This message is sent to a radio to re-enable itself.
This message is addressed to a radio to instruct it to close its
microphone.
This message is addressed to a radio to instruct it to open its
microphone.
Navigate to this area from the main window in RDPS by clicking on
the CCE cards in the upper right, then System Parameters,
Miscellaneous Parameters.
System-Specific Definitions
287
Advertisement
Table of Contents
