Table of Contents
Advertisement
Set Specifications / MAP27 Interface to ENABLED
Set Miscellaneous Controls / PTT Initiation of Call to ENABLED
Set UIM Setup / UIM to DUAL PORT
Set UIM Setup / MAP27 Data Rate to 9600
Set Unit – Identity / Call Queuing to UNANSWERED or NONE
Set Unit – Identity / Radio is a Dispatcher to DISABLED
Set Own fleet parameters / Full off air call setup to DISALLOWED
Tait TM8255 Programming
External audio connections to the transceiver are not pre-configured from the factory and
must be both enabled and customized via the proper Tait programming software. This
pertains particularly to lines 7 and 13 (AUD_TAP_IN & AUD_TAP_2). Set the following
parameters in the Tait radio programming software:
Note
Note
1. Click Global Features on the left, then the MAP27 tab.
2. Set the following:
a. MAP27 Enabled = (yes)
b. MAP27 Port = AUX
c. Baud Rate = 9600
d. Link Layer Type = Full 1.5
3. Click PTT on the left, then the External PTT (1) tab.
4. Set the following:
a. Audio Source = Audio Tap In
5. Click Programmable I/O on the left, then the Audio tab.
Many radio settings are not mentioned in the following procedure;
either those settings don't apply to the Zetron Console application,
or they are dependent on the individual user's trunking
environment and personal preferences.
This procedure is based on v5.8.0.1 of the TM8200 Programming
Application. Other versions of the application may have different
names or locations for settings.
MAP27 Wireless Interface Option
123
Advertisement
Table of Contents
