return Simul-select or Patch buttons to their idle states if the operator does not select a
resource for use in the simul-select or patch within the period for which the timer is
currently set.
Also, if the operator presses the Simul-select or Patch button, makes the resource
selection, but fails to press the Simul-select or Patch button again, the function button will
still revert to its idle state when the timer reaches its timeout value.
If the timer is disabled (set to zero seconds = OFF), the operator must terminate Simul-
select and patch operations manually.
Volume and Muting Options
Tip
Figure 82: Volume and Muting Options Dialog Box
Setting the Volume Control Levels and All-Mute Timer
The operator may set the speaker volume settings for each position including the Default
volume, Muted volume, and Minimum volume settings. Each value may be set between
zero and 99 representing the percentage of total volume. The percentage entered is
rounded to the nearest multiple of three.
The first time configuration is reloaded with a new setting for the Default Volume, a "Save
Display" needs to be done in order for that setting to be saved for the next reload or restart.
For more information on saving a display, see Series 4000 Communication Control System
Operation (P/N 025-9535), the subsection on "Saving the Channel Display
Configuration."
The Default Volume is used to set the default volume level of all channels for a position.
Navigate to this area from the main window in RDPS by clicking
Misc Params, Volume and Muting Options.
System-Specific Definitions
309