ZETRON 4000 Series Installation Manual page 33

Table 4: Console Cardcage Power cable
Pin
1
2
3
4
5
6
7
8
9
10
11
12
Table 5: Channel Cardcage Power Cable
Pin
1
2
3
4
5
6
7
8
Wiring the Model 4048 Power Supply

To wire the power supply
1. Connect AC input power to the modular AC input jack on the back of each power
supply.
2. Connect 12 V
supply.
Both AC and DC inputs may be connected at the same time where the DC input
provides a backup to the AC power source.
3. Connect the power cables (three wire bundles) exiting from the back of each
Model 4048 power supply to each cardcage Refer to
4. Although the power supplies are factory adjusted, you may want to further adjust
them once they are connected to load. See
Color Purpose
Purple Not Used
White Error Signal
Yellow +12 V
DC
Blue +5 V
DC
Brown Ground
Black Ground
Black Ground
Brown Ground
Blue +5 V
DC
Yellow +12 V
DC
Grey -12 V
DC
Green Not Used
Color Purpose
Yellow +12 V
DC
Red +5 V
DC
Brown Ground
Black Ground
Black Ground
Brown Ground
Red +5 V
DC
Yellow +12 V
DC
power on the screw-terminal block on the back of each power
DC
Model 4048 CCE Set Up
Connector Part Numbers:
• Connector: 401-0116
• Hood: 401-0117
Please check both connector
markings and the silk screen
on the cardcage to ensure
proper alignment before
installing cable.
Connector Part Numbers:
• Connector: 401-2649
• Hood: 401-2650
Please check both connector
markings and the silk screen
on the cardcage to ensure
proper alignment before
installing cable.
Figure 10.
Adjusting the Power Supply
on page 34.
33