Table of Contents
Advertisement
IntegratorRDPS Programming
Parameter/Area
Retry Time
TX Hold Time
TX Pre Time
Channel ID
Emergency
Call Alert
Selective Call
Voice Delay
Squelch Signaling
Busy Channel Lockout
Status Request Response
Radio Check Response
Radio Enable/Disable
274
The time between sending an MDC1200 message and re-sending the message if
no acknowledgement or response is received. Retry Time can be programmed
from 1 to 15.5 seconds in 0.5-second intervals. A random value between 0 and
1.8 seconds is always added to this value to prevent collisions.
The delay after the end of the MDC1200 data before the transmitter is unkeyed.
The delay after the transmitter has been keyed before the MDC1200 data is
sent.
Regardless of the type of the call being transmitted, individual or group call, the
individual ID is included as the source ID by the channel card when
transmitting an MDC-1200 message.
Do not configure the individual ID of the channel card to the same ID used by
another field radio. The channel card will ignore incoming calls from its own
ID.
The Group ID is used for decoding incoming group calls.
With Emergency Ack enabled, the channel card automatically sends an
emergency acknowledge upon receiving an emergency alert.
With Emergency Tone enabled, the workstation provides an audio feed back
upon receiving an emergency alert.
The Aux Output Number is the output activated upon receiving an emergency
alert.
With Call Alert Response enabled, the channel card sends an automatic
response upon receiving a call alert.
With Call Alert Beep the workstation provides an audio feed back upon
receiving a call alert.
Call Alert with Voice enables/disables voice reception after receiving a call
alert.
The Call Alert Aux Output Number is the output activated upon receiving a
call alert.
With Selective Call Beep enabled, the workstation provides an audio feed back
upon receiving a selective call.
The Selective Call Auxiliary Output is the output activated upon receiving a
selective call.
This selection enables/disables voice delay in the channel card.
This selection enables/disables squelch signaling in the channel card.
This selection enables/disables busy channel lockout in the channel card.
When active the channel card sends an automatic response upon receiving a
status request.
When active the channel card sends an automatic response upon receiving a
radio check.
When active this selection allows a user at another radio or console to enable or
disable the console from accessing the radio attached to this channel card.
Purpose
025-9533Y
Advertisement
Table of Contents
