Table of Contents
Advertisement
IntegratorRDPS Programming
Table 100: MDC-1200 System Parameters window
Parameter/Area
Tone Setting
Selective Call Mode
Emergency Mode
Confirmation
Password
Emergency Channel
286
If Side Tone is enabled, the workstation sends a tone for the duration of MDC-
1200 signaling.
If Talk Beep is enabled, the workstation sends a go-ahead-to-talk beep when
MDC-1200 signaling is completed and voice transmission may begin.
Both tone settings are ignored if the transmitting channel has voice delay
enabled.
If set to toggle, after selective call is activated, it stays active until the selective
call button is pressed again. If set to momentary, after the transmission is
complete, the selective call function is automatically deactivated.
In normal mode, when an emergency alert is sent, the workstation provides
visual feedback, whereas in silent mode, it does not.
If an Emergency Channel and (optionally) Frequency are programmed any
Emergency Alert will be sent on this Emergency Revert Channel and
Frequency. If no Emergency Channel is programmed the currently selected
channel is used.
The workstation system may be configured to require a confirmation before
sending a Call Alert, Emergency Alert, Emergency Acknowledge (manual
initiation only), Radio Check, Status Request, Radio Disable, Radio Enable,
Radio Monitor Enable or Radio Monitor Disable. When required the
confirmation is requested after the subscriber and function is selected. It
summarizes these two selections.
For a description of these commands, see
Commands)
on page 287.
If a password is defined, the dispatcher must enter the password to confirm
certain commands such as enabling and/or disabling the Radio and Remote
Monitor.
Select the channel where emergency calls should be routed to. Only MDC-
1200 channels are displayed here.
Purpose
Confirmation (MDC-1200
025-9533Y
Advertisement
Table of Contents
