Programming; 5/6 Tone Ani Decoding; Selection Of Tone Set - ZETRON 4000 Series Installation Manual

Table of Contents

Advertisement

Console ANI Programming
RSC is used to allow field radios to selectively call an individual console operator. Utility
customers most often use this. In this mode, the signaling sent from the field radio starts
with a destination address (console operator address) and ends with a source address
(ANI). In actual operation, the console operator address attempts to match the destination
address digits with its CPSW-programmed primary or secondary address. When a match
occurs (within the CPSW-programmed time period), the console beeps its operator,
unmutes the channel, and transfers the following ANI digits into the display buffer so that
the operator may see who is calling. The console allows signaling to be received on all
channels simultaneously and may queue up several decodes per channel. The ANI display
buffer holds up to 24 ANIs (from all channels) with the oldest being displayed first. By
pressing the ANI Review Key, the ANI being displayed is removed from the queue and
the next oldest is displayed. When ANI information no longer appears in the display
buffer, the time is returned to the display. For a detailed description of operation, refer to
the appropriate operator's manual listed in

Programming

In addition to defining the ANI type on the DCC, the console requires programming with
CPSW. Refer to

5/6 Tone ANI Decoding

There are four versions of the Dual 5/6 Tone ANI, depending on the tone set that you wish
to decode: ZVEI, CCIR, EEA, OR EIA. See
timing requirements.
Figure 44: Five-Tone Sequence

Selection of Tone Set

Within the ZVEI Tone System, there are four possible tone sets.
The EEA, EIA, and CCIR tone systems have only one possible tone set. Only digits 0-9
are displayed. A minimum of five tones is required before the system will display. See
Table 89
for a list of tone frequencies used for the various tone sets.
232
ANI Decode / Display
T1
T2
T3
T4
One Code Sequence
Table
1.
on page 213 for ANI programming directions.
Figure 44
and
Table 89
T5
for tone formats and
025-9533Y

Advertisement

Table of Contents
loading

This manual is also suitable for:

41184115b40184217b4219

Table of Contents