Table of Contents
Advertisement
If a primary or secondary ANI address is programmed, and your radios support RSC, and
Spare Outputs 7 and 8 are not programmed, then Spare Outputs 7 and 8 will function as
follows:
• Spare Output 7: ON when ANI is displayed on the console display, OFF otherwise
• Spare Output 8: Produces a 500 ms pulse when an ANI is decoded by the console
Auxiliary Input
By assigning an input to this key, the associated LEDs will reflect the state of the input.
Pick the desired inputs by entering the input numbers. The input must have been
previously defined using the System Configuration menu. Then select the desired LED
behavior.
Auxiliary Output Interlocked
Several outputs may be "interlocked" such that only one output can be active at any given
moment. That is, when one output goes active, all others will be inactive. Up to 32
interlock groups may be defined with any number of outputs per group.
Enter the desired output number up to 240. The output number will be accepted if it has
been previously defined using the System Configuration menu.
Type an interlock group number 1 - 32. If the interlock group has been already used, this
input will be added to it. If not, a new interlock group will be created.
Auxiliary Output Toggle
The chosen output will toggle with this key. That is, press the key once and the output will
be activated; press again and the output will deactivate.
Auxiliary Output Momentary
As long as this key is pressed, the output will be active; when released, the output will be
inactive.
Spare Output
Spare Output Latching
The eight spare outputs are located on pin block P1 of the Models 4118 and 4116B and on
P7 of the Model 4018 console. When an output is ON, its voltage is greater than +3.5 volts
DC relative to ground. When the output is OFF, its state is less than +0.5 volts.
If Spare outputs 7 and 8 are not reprogrammed, Spare Output 7 will be ON whenever an
ANI is displayed on the console and Spare Output 8 will produce a 500 ms pulse every
time an ANI is decoded by the console.
The assigned spare output will toggle on and off with each press of the spare output
latching key. The red LED will toggle to show the state of the output.
Description of Key Functions and Parameters
387
Advertisement
Table of Contents
