Table of Contents
Advertisement
Wireless Interface Options
The MAP27 Wireless Control Card is installed in the Series 4000 Common Control
Equipment (CCE) rack. The interface module and MAP27 radio are located within 1000
feet (300 m) of the common control equipment rack. Each interface module is provided
with a cable to connect the radios (see
The MAP27 Wireless Interface Module (WIM) provides level conversion and 4-wire
audio from the MAP27 Wireless Control Card to the MAP27 radio.
Figure 27: Series 4000 MAP27 Wireless Interface Option Components
IntegratorRD
Console
The MAP27 Wireless Interface Option can be added to existing IntegratorRD console
systems with the addition of the MAP27 Wireless Control Card, the Zetron MAP27
Wireless Interface Module, software upgrades to the Console Interface Card, and the
console itself. Adding the MAP27 capability to an existing system has no effect on the
existing channels and other console functions are not affected.
Both channels on the MAP27 Wireless Control Card must be MAP27 interface channels.
The MAP27 interface can coexist with other conventional channel interfaces.
112
Series 4000
Common Control
Equipment
MAP27 Dual Channel
Wireless Control Card
950-0015
Punchdown
Block
MAP27 Wireless
Interface Module
MAP27 Wireless
Interface Module
Note
Do not mix old system (4024) cards with new system (4020/4048)
cards in this process.
Table
46).
Figure 27
shows the option components.
Cable 709-0004
Installation Specific
(up to 1000 feet/300 m)
(radio specific )
(radio specific )
Radio-specific
interface cable
MAP27
Radio #1
MAP27
Radio #2
025-9533Y
Advertisement
Table of Contents
