Table of Contents
Advertisement
3. Locate the Data-to-CCE cable. Connect the 9-pin D-connector end of the cable to
the socket marked
4. Route the Data-to-CCE cable to the Common Control Equipment cabinet. Connect
the 6-pin modular plug end of cable to the console
5. Locate the Voice-to-CCE cable. Connect one end to the connector on the rear panel
of the Model 4219 labeled
Equipment cabinet and plug it into the console
6. Locate the Audio Y-cable (709-0123) and plug it into the jack on the rear of the
Model 4219 marked
and right amplified speakers as appropriate.
7. Locate the two Power Y-cables (709-0159 and 709-7938). One of the plugs has a
threaded locking ring. Insert that plug into the connector on the rear of the Model
4219 labeled
12V PWR
8. Install the strain relief provided with the Model 4219 to prevent the cable from
becoming disconnected. See
158 for instructions on how to do this.
9. Plug the second Power Y-cable into either one of the sockets on the Y-cable
connected to the Model 4219. Plug the 12V power supply that came with the
Model 4219 into the remaining socket on that Y-cable.
10. Connect the two free sockets on the second Power Y-cable to the power leads
going to the external amplified speakers.
11. (Touch-screen) If an installer-supplied touch screen monitor is used, connect the
touch screen cable connector marked
monitor. Connect the opposite end, marked
the USB connectors on the back of the PC.
12. Connect the 15-pin CRT video cable to the video connector on the PC.
13. Connect the mouse or trackball cable to the PC.
14. Connect the PC keyboard to the PC.
15. Connect the AC power cords for the PC and the monitor.
Figure 47
shows the cabling for an IntegratorRD workstation. The PC port locations that
are shown are for example only; they may not match your PC's configuration.
Note
To add a Zetron Desktop Microphone, see
Microphone
on the dual RS-422 card in the console position PC.
CCE
. Route the other end to the Common Control
VOICE
AMPLIFIED SPEAKERS
and turn the locking ring tight.
Model 4219 Power Connection Strain Relief
To Touch screen
on page 220
Hardware Installation
connection there.
DATA
connection there.
VOICE
. Connect the other end to the left
to the touch screen
To Touch screen Controller
Zetron Desktop
on page
to one of
243
Advertisement
Table of Contents
