Table of Contents
Advertisement
IntegratorRDPS Programming
Selecting the Instant Call Type
You may specify how the call is directed and the channel action to be taken. The Instant
Call Type field allows selection by one of the following methods:
Transmit: Transmits the page on the currently selected channel(s). The selected state for
all channels is not changed.
Select-then-Transmit: Selects the channel(s) identified in the Channel Set field before
the page is transmitted.
Instant Transmit: Transmits the page on the channel(s) identified in the Channel Set
field. The selected state for all channels is not changed.
Channel Setup: This is a non-transmitting Instant Call Page type that is used for
transmitter setup such as changing talk groups. iDEN and MAP26 channels cannot be
selected for a Channel Setup because their channel setup requires a transmit.
Setting the Paging Capcodes
The Capcode(s) field allows you to specify the pages to be performed when this instant
call is selected. More than one page may be "stacked" by listing several capcodes
separated by commas. For example: 112, 114
The first digit of the capcode specifies the format of the page as defined by the encoder
configuration (described above). If too few, too many, or incorrect digits are entered, the
entry is rejected and a warning message displayed.
Setting MAP27 Call Capcodes
Instant call buttons can be used to setup calls, send status and SST messages, and change
dynamic group settings for MAP27 radios (details below). The valid entries for MAP27
instant call pages are: (note: example use leading digit 7 and radio id 25)
Setup normal individual call:
<leading digit><radio id>#
For example: 725#
Setup emergency individual call:
<leading digit><radio id>#E
For example: 725#E
Setup priority individual call:
<leading digit><radio id>#P
For example: 725#P
Send status call:
<leading digit><radio id>S<status number>
Status number ranges from 1 to 32. For example: 725S9
322
025-9533Y
Advertisement
Table of Contents
