Table of Contents
Advertisement
Console Programming System
5. If needed, repeat this procedure to copy the position layout to additional positions.
Position Cross Muting
The Position Cross Muting function lets you mute common channels between operator
positions when transmission is occurring. Using cross muting eliminates feedback
problems from physically close operator positions.
To configure Position Cross Muting
This feature requires at least two configured positions.
1. Click Edit, Position Configuration.
2. Use the up and down arrows next to the Position number to select the position to
enable cross-muting.
3. Click Position Cross Muting.
A cross muting dialog box opens.
4. Mark the checkbox for any position you wish to cross-mute. Clear the checkbox
for any position you wish to turn off cross-mute.
5. Click Done when you are finished.
Audio Controls
This function sets volume and speaker muting for each position.
To configure Audio Controls
1. Click Edit, Position Configuration.
2. Use the up and down arrows next to the Position number to select the position to
configure.
3. Click Audio Controls.
The Audio Controls dialog window opens.
4. Configure the audio control settings as needed. The following table explains each
setting:
Muted Audio Level *
Minimum Audio Level *
Default Volume Level *
Speaker Mute while
Transmitting
212
This number (0 to 99) represents the percentage of total volume to be used
as a muted audio level for all channels of the position.
This number (0 to 99) represents the percentage of total volume to be used
as a minimum adjustable audio level for all channels of the position.
This number (0 to 99) represents the percentage of total volume to be used
as a power-up default volume level for all channels of the position.
When enabled, both select and unselect speakers will mute when you are
transmitting. Disable if you want speakers to remain unmuted.
025-9533Y
Advertisement
Table of Contents
