ZETRON 4000 Series Installation Manual page 143

Harris M7100 Wireless Interface Option
Video Console Operation
Refer to Series 4000 Communication Control System Operation (P/N 025-9535) for
general operation. The following describes the features of the Orion interface.
There are two display lines within each channel control module to indicate the mode and
state of the attached Orion radio (see Figure 32).
Figure 32: Display of Orion Mode and State
CHANNEL TITLE
CALL
(System)
(TALKGRP)(S)
51
These two lines basically mimic the display information of the two lines on the control
head of an Orion radio.
The upper line displays the selected "system" when the radio is not transmitting or
receiving. When a call is received, this display shows the individual ID (or alias) of the
calling party.
The lower line displays the selected talkgroup and the scan mode. This line also indicates
emergency status with *RXEMER* and *TXEMER* displayed in white letters on a red
background, alternating with the talkgroup. When an individual call is in progress, the
lower line will display *INDV*.
An antenna logo is displayed in the upper-right to indicate transmission on an Orion
channel.
Console Error Displays
In the eight-character display on the console reserved for Orion radio information, errors
may be displayed if communication between the Orion Dual Channel Wireless Control
Card and the Orion radio are unsuccessful.
RCOM-ERR
This display indicates a communication error has occurred between the radio and the
Orion Dual Channel Wireless Control Card. This error can be caused by improper setup,
disconnection between the dual channel card and interface module or between the
interface module and radio, or loss of power to the radio.
143