Table of Contents
Advertisement
Review and Save Channel Configuration
To make the configuration permanent and active
1. Backspace until the following menu is displayed:
Define,Review,Store,Init,<BS> :
2. Press R to review and verify the new configuration. Then press S.
Options Configuration
To configure the channel card audio memory options
1. From the main menu, press C and then O.
Dram,enableIrr,Store,<BS> :
2. Press D to set the DRAM option.
This menu is displayed:
Press R to specify that the audio memory module is required. The entire channel
card is disabled if the memory module is missing or bad.
3. OR
Press O to specify that the audio memory module is optional. Only the Instant
Recall Recorder and Voice Delay features are disabled if the memory module is
missing or bad.
Note
4. Press I to enable the Instant Recall Recorder option for both channels. This is
usually done at the factory when the option is ordered but may be done later as an
upgrade.
5. Enter the Access Code received from the factory and press Enter.
The following message is displayed:
4 Mbyte IRR memory enabled.
Then the following menu is displayed:
Dram,enableIrr,Store,<BS> :
6. Press S (Store) to enable the option and make it permanent.
Warning! When using the IRR option, disable the guard tone delay.
STOP
Reqd,Optl,<BS> :
The following configurations support the Instant Recall Recorder
option:
Support IRR Option
4018, 4118, or 4116B consoles w/ software version 1.50 or higher
4118/4018 CPSW software version 1.4 or higher
All 4217B consoles and IntegratorRD workstations
Doing so prevents an echo effect on the IRR outputs. To
disable the guard tone delay, see
page 56.
Configuring Channel Cards
Step 6
in section
Type
on
61
Advertisement
Table of Contents
