Table of Contents
Advertisement
Appendix C: CPSW Reference Material
Page Enter
This paging function is used during manual page entry (via the console DTMF/paging
keypad) to terminate the entry and add the page to the stack. The use of this key is only
required for variable-length paging formats (i.e., DTMF). Fixed-length paging formats
(i.e., Two-Tone and Alerts) are self-terminating.
Page Clear
If manual page entry (via the console DTMF/paging keypad) is in progress, this function
will abort the current key entry sequence and clear the paging display without altering the
existing page stack. If a page entry is not in progress, pressing this key will delete all
console page stacks. If a page transmission is in progress, it will also immediately abort
the page transmission. This function should always be programmed if the console is to be
used for paging.
Page Send
This paging function will terminate any manual page entry in progress (as if a PAGE
ENTER key had been pressed), and begin transmitting the manual page stack on the
currently selected channel(s) in the order the pages were stacked (entered). The page stack
is retained and can be transmitted again (on different channel(s), for example) by pressing
this key again.
Page Safety
If this function is programmed, instant-call pages will not be transmitted until this key is
pressed, allowing the operator to review the selected instant-call pages before sending
them. If this key has not been programmed, pressing an instant-call page key will begin
the page transmission immediately.
Speaker Monitor Keys
This key will allow the unselect audio to be routed to two additional speakers besides the
console's own "unselect" speaker. This function is most commonly used with Zetron
Model 4117 Console Monitor.
The first time a Monitor A/B selection is made, the "Channel Select" key's green LED will
flash, indicating its association with the pressed Monitor key. The next time a Monitor A/
B selection is made, the green LED will stop flashing, indicating that channel's unselected
audio will now be sent to the Unselected Speaker (i.e. it acts as a toggle function between
the Unselect Speaker and the Monitor A/B Speaker).
Burst Tone Select
A 1-second tone burst can be enabled by selecting a frequency from the list. This tone
burst is generated for each transmit function after the transmitter is keyed-up and before
the console audio is switched on. Several keys can be programmed with different
frequencies. The tone burst can be disabled by selecting a key programmed with the "No
384
025-9533Y
Advertisement
Table of Contents
