Table of Contents
Advertisement
MDC-1200 System Parameters
Tip
Figure 64: MDC-1200 System Parameters window
The parameters listed here are not shown in RDPS unless the Full-Featured MDC-1200
option is selected. Also, these features are not used by IntegratorRD consoles unless they
have the appropriate optional license installed at every position.
If Basic MDC-1200 is selected:
• No MDC-1200 encoding is supported
• MDC-1200 decoding supported are: emergency and non-emergency PTT ID
• Only Emergency Acknowledge and Emergency Tone channel parameters are
configurable, but the Extended Paging option for the console is required in order to
send the Ack as a message from the base station over the air
Caution!
!
If Full-featured MDC-1200 is selected:
• MDC-1200 license is required per position
• All MDC-1200 encoding and decoding are supported
Navigate to this area from the main window in RDPS by clicking on
the CCE cards in the upper right, then System Parameters,
MDC-1200 System Parameters.
If a Zetron iRIM is in use, the Emerg Ack function is not
transmitted to the radio network due to design limitations.
System-Specific Definitions
285
Advertisement
Table of Contents
