Table of Contents
Advertisement
Scan Type (Parameter) = ProSound/ProScan (Option 2)
Note
This option allows the radio to scan for its system (site) control
channel to ensure that the site remains active. If 'Option 1 =
Disabled' is selected, then the system scanning of the radio is
completely disabled. If 'Option 3 = Wide Area' is selected,
then the radio should not be used as a fixed location radio that gets
connected to the console system. The 'Option 3 = Wide Area'
setting should only be used in radios that are capable of roaming
from site to site such as those that are installed in vehicles would
be used in this manner. The 'Option 3 = Wide Area' setting is
known to cause problems with the system if it's used in fixed
location radios that are connecting to the system.
6. Under Network Options, enable Dual Control. Accept all the default selections
under Dual Control.
Note
If the radio currently connected to the Zetron CCE does not have a
factory control head installed, it is not necessary to program the
radios for dual control head operation.
7. Initiate programming of radio.
8. Select Mobile Options. Select CUB from the Control Head ID list. Press OK to
close mobile options. Press OK to continue programming.
9. Upon completion of programming, power down the radio at the control head.
10. Connect the Zetron common control cable into the in-line programming cable.
Leave the control head turned off; the control head display will be dark.
11. Initiate programming of radio.
12. Select Mobile Options. Under Mobile Options select write system keypad file.
Select CUA from the Control Head ID list. Press OK to close mobile options.
Then press OK to continue programming.
13. Upon completion of programming, remove programming cable and plug Zetron
common control cable directly into radio.
14. Cycle power on the radio by removing and reattaching the power cable on the rear
of the radio.
15. Turn the radio on at the control head.
16. The display should read *DUAL*.
The radio is now configured for dual control head operation.
Note
"Dual" control head programming has the following affect on the
radios. When attempting to gain control of the radio from either the
radio's attached control head with the "first mic" or from the
IntegratorRD console position, PTT must be pressed twice before
any audio is passed.
Harris M7100 Wireless Interface Option
141
Advertisement
Table of Contents
