Table of Contents
Advertisement
IntegratorRDPS Programming
MAP27 System Parameters
Figure 63: MAP27 System Parameters window
Table 99: MAP27 System Parameters window
Parameter/Area
Trunk outgoing calls
when busy
Go To Channel Beep
Call Failed Beep
Call Cleared Beep
284
Tip
Navigate to this area from the main window in RDPS by clicking on
the CCE cards in the upper right, then System Parameters,
MAP27 System Parameters.
With this option enabled, if an outgoing call is made on a busy channel, the
call is trunked to the first available channel. With this option disabled, a
busy indicator is displayed.
With this option enabled, when an operator transmits on a MAP27 channel,
a beep is activated when the channel is ready for the operator to talk.
With this option enabled, when an operator transmits on a MAP27 channel,
a "call failed" beep is activated if the call failed because of a system busy,
unit busy, or out of reach.
With this option enabled, when IntegratorRD receives a call cleared
message on a MAP27 channel, a "call cleared" beep is activated.
Note
In a typical S4000 system installation, radio equipment is generally
installed in a back room, and is not within earshot of the console
operator. For this reason, some of the tones that are normally
heard through the MAP27 radio hardware are optionally provided
through the console application.
Purpose
025-9533Y
Advertisement
Table of Contents
