Table of Contents
Advertisement
Wireless Interface Options
Table 56: Channel options for earlier firmware versions (current version does not require
setting)
Programming the Dual Channel Wireless Control Card
This programming section is for the Dual Channel Wireless Control Card (P/N 950-9867)
only. The Dual Channel Wireless Control Card is used for systems with a Harris M7100,
Jaguar 725M, or an Orion radio.
To configure the Dual Channel Wireless Control Card
1. Use a terminal set for 19200, 8, N, 1 (with no flow control) to connect to the
monitoring port on the front panel using the Zetron cable P/N 709-7452.
2. Once connected, press Esc to get the following menu (the version number may
vary, and your options may vary based on your version):
3. Menu choices are activated by pressing the appropriate capitalized letter. You can
press Esc at any time to return to the main menu. Typing a question mark "?" gives
you the current configuration that should look something like this sample:
134
Channel
Switch
1
2
B
3
4
5
6
A
7
8
Note
For programming Universal cards (P/N 950-9819) and Tone/Local
cards (P/N 950-9820), see
Orion v1.24.01, 2013-MAR-24
---Press <ESC> anytime to return to this menu---
?,Config : ?
DCC Serial_No:: 0000B4F6
--- 4048 ChA/B number = 3/4
Active ChA config. ________
Ch Type = Orion
Diag. Log Disabled
Radio Volume=100%
VOX Enabled
VOX Threshold=-18dB
VOX Decay Time=0.5sec
Active ChB config. ________
Ch Type = Orion
Diag. Log Disabled
Radio Volume=100%
VOX Enabled
VOX Threshold=-18dB
VOX Decay Time=0.5sec
AudioDRAM installed = None or Bad.
---Press <ESC> anytime to return to this menu---
Label
Type of Selection
BTI
Not used, set OFF
OPT (upper)
TX blocking, set OFF
OPT (lower)
Not used, set OFF
FD
Full Duplex, set ON
BTI
Not used, set OFF
OPT (upper)
TX blocking, set OFF
OPT (lower)
Not used, set OFF
FD
Full Duplex, set ON
Configuring Channel Cards
on page 48.
025-9533Y
Advertisement
Table of Contents
