IntegratorRDPS Programming
The Position Cross Muting window
Positions to Mute.
Figure 61: The Position Cross Muting window
To configure Position Cross Muting
1. To identify position numbers, start IntegratorRD and, in the upper right-hand
corner of the application, see the number following the hyphen.
2. Identify the position number of the Active Position. The Active Position is the
operator position whose speakers need to mute the transmissions of adjacent
positions. For our example, the operator position is 2.
3. Identify the position numbers of the Positions to Mute. Positions to Mute are the
adjacent positions whose transmissions shall be muted at the Active Position. For
our example, the positions adjacent to position 2 are positions 1, 3, and 8.
4. Find the Active Position row (in our example, row 2 for position 2) and mark the
check boxes for each adjacent position (in our example, 1, 3, and 8). See
This mutes transmissions from position 1, 3, and 8 on position 2.
5. Configure additional position cross muting as needed.
6. Click OK.
7. Save the configuration and either restart IntegratorRD or reload its settings.
282
Tip
Use Mute All to have all positions mute the transmit audio of all
other positions. Use Unmute All to have all positions play the
transmit audio of all other positions.
61) has a matrix of Active Positions and
(Figure
Figure
61.
025-9533Y