Table of Contents
Advertisement
configured using their various jumpers and switches, then installed according to the
mapping. In addition, before wiring starts, configure the jumpers on the consoles.
Wiring
After the system has been configured, the wiring of the system may begin. The system will
require wiring between the CCE and the radio base station, between the CCE and the
consoles, and between the consoles and their various accessory options (such as speakers,
microphones, encoders).
Console Programming
Once the wiring is complete, the consoles can be programmed, if needed. In many cases
consoles are configured at the factory. Button-based consoles are configured using CPS or
CPSW. PC-based consoles are configured using IntegratorRDPS.
Note
Testing
When planning, mounting, configuring, and wiring have been completed, the system is
ready for its first installed test. The system has been tested at the Zetron factory; this
preliminary system check verifies proper configuration and wiring.
Level Setting
The last step is to adjust the audio levels in the system. Factory default settings are merely
a starting point, as each site is unique. Adjustments must be performed at every "system
port", which includes receive and transmit audio levels at every channel, and at every
console.
Operation
During its initial operation, the system will operate according to the programming done at
the Zetron factory. If you wish to alter operation through programming, consult the
appropriate programming manual as listed in
be performed by Zetron, or you may make changes once the system has been installed. If
necessary, contact Zetron for further assistance.
Every version of the IntegratorRDPS programming software is
matched to a limited range of hardware and firmware. Check with
Zetron Technical Support if you are upgrading or adding to a
system.
Table
Installation Sequence
1. Changes in the programming may
23
Advertisement
Table of Contents
