Wireless Interface Options
Zetron Model 427 Peripheral Interface Programming
To configure the Model 427, use the Zetron M827Base for Windows programming
software as described in the following procedures.
First the Zetron M427 dispatcher port must be programmed to support the interface to a
Zetron console.
To configure the Dispatcher Port
1. Start the M827BASE for Windows application.
2. Navigate to Site Configuration Editor, Edit, Dispatcher Ports Editor.
3. Define the Site Selection number that is being configured to work with the S4000 /
IntegratorRD console system.
4. Define the Dispatcher Port Number. This is the M427 data port connected to the
M4217.
5. Ensure that the Baud Rate is set to 9600.
6. Ensure that Port Mode is set to Extended MAP27.
7. Save the entries.
126
Note
Many of the dispatcher programming parameters are not listed
below; either they don't apply to the Zetron Console application, or
they are dependent on the individual user's trunking environment
and personal preferences.
025-9533Y