Table of Contents
Advertisement
IntegratorRD Workstation Installation
3. Attach the 9-conductor end of the Model 4217B CCE cable to the PC connector
marked CCE. The 6-conductor modular telephone connector on this cable is then
routed to the console DATA connection in the Common Control cabinet.
4. (Touch-screen) If an installer-supplied touch screen monitor is used, connect the 9-
connector touch screen cable marked To Touch screen to the touch screen
monitor. Connect the opposite end, marked To Touch screen Controller to the
COM1 or SERIAL1 connector on the back of the PC.
5. Connect the 15-pin CRT video cable to the video connector on the PC.
6. Connect the mouse or trackball cable to the PC.
7. Connect the PC keyboard to the PC.
8. Insert the AC power cables for the PC CPU, CRT, and Model 4217B Audio Panel.
Figure 46
shows the cabling for an IntegratorRD workstation. The port locations that are
shown are for example only; they may not match your PC's configuration.
240
Note
To add a Zetron Desktop Microphone, see
Microphone
on page 220
Zetron Desktop
025-9533Y
Advertisement
Table of Contents
