JUMO LOGOSCREEN 601 Operating Manual page 224

9 Configuration – in setup program only
Variables bool_out01 to bool_out40
Parameter
Description
Designation
Variables real_out01 to real_out40
Parameter
Description
Designation
Temperature
Unit
Scaling start
Scaling end
Decimal places
Variables alarm01 to alarm08
Parameter
Activation
Alarm/Event list
?
224
Selection/text/value
<Enter text>
Use default text or enter
other text.
<Enter text>
Use default text or enter
other text.
Selection/text/value
<Enter text>
Use default text or enter
other text.
<Enter text>
Use default text or enter
other text.
None
Relative
Absolute
<Enter text>
%
-99999 to 99999 (0)
-99999 to 99999 (100)
Auto
XXXX.
XXX.X
XX.XX
X.XXX
Selection/settings
Off
On
Off
Event
Alarm
Description
Description of the Boolean output variables
Abbreviation of variables
Description
Description of the real output variables
Abbreviation of variables
This selection is important for the automatic con-
version in case of a change in temperature unit
(°C/°F) (see system data).
The value is not a temperature.
The value is a temperature difference.
The value is a temperature value.
Value unit (if it is not a temperature)
Minimum admissible value
Maximum admissible value
Number of pre-decimal and decimal places for dis-
playing the value
Automatic
No decimal place
One decimal place
Two decimal places
Three decimal places
Description
Alarm (signal monitoring) is inactive.
Alarm (signal monitoring) is active.
In the event of an alarm, only the alarm signal is
activated.
The alarm/event text is entered in the event list.
The alarm/event text is entered in the alarm list
and the event list. The collective alarm is activated
and the text of the last alarm to occur is displayed
in the status bar.