JUMO LOGOSCREEN 601 Operating Manual page 162

7 Configuration
Parameter
Parameter
Display channel
information
Measured value
display
Show envel. dia-
gram
Show digital trac-
es
Diagram type
Display channel
description
Display auxiliary
lines
162
Selection/settings
This parameter is used to switch on and switch off the channel information display
in the curve diagram: channel designation (e.g., A1) along with the abbreviation of
the analog or digital signal (e.g., AI01 for analog input 1) and numerical display of
the analog value.
No
Yes
The parameter determines which value is shown in the diagram header (only for
curve presentation and when min./max. value recording is activated; see the pa-
rameter "Memory values".
Min.
Max.
The parameter determines whether the measured values are shown as an enve-
lope diagram or a line in the curve presentation (only when min./max. value storage
is activated; see the parameter "Memory values"). If the data is not stored as min./
max. values, the parameter has no effect.
No
Yes
The parameter determines whether the digital traces (digital signals) are shown in
the curve presentation along with the analog signals.
No
Yes
The diagram can be displayed vertically or horizontally.
Vertical
Horizontal
The parameter determines whether the channel description (e.g. analog input 01),
rather than the abbreviation (e.g. AI01), is displayed in the channel information of
the curve diagram.
No
Yes
The parameter determines whether the auxiliary lines (level lines) are shown in the
curve diagram.
No
Yes
Description
Display disabled
Display enabled
The min. value is displayed.
The max. value is displayed.
The min./max. values are displayed as a
line.
The min./max. values are displayed as
an envelope diagram.
The digital signals are not displayed.
Digital and analog signals are displayed.
Diagram runs from the top down.
Diagram runs from the right to left.
The abbreviation is displayed.
The channel description is displayed.
The display of auxiliary lines is deactivat-
ed.
Auxiliary lines are displayed if this has
been activated in the configuration of the
analog channels for the respective auxil-
iary line.