JUMO LOGOSCREEN 601 Operating Manual page 137

Paperless recorder with touchscreen
Hide thumbs Also See for LOGOSCREEN 601:
Table of Contents

Advertisement

Parameter
Time base
Threshold value
Reset signal
Individual settings Instead of the general settings for the synchronization time, daily start, daily end,
Type; Additional storage
Selection "annual" or "total": the counter/integrator status is temporarily stored at the end of each month,
but not reset to 0. This means that the current status is always available for evaluation with the PCA3000
evaluation software at this point in time.
Selection/settings
"Integrator" function: The current measured value is integrated corresponding to the
selected time base, taking the factor into consideration:
Second
Minute
Hour
Day
"Operating time" function: The time base specifies the unit in which the operation
time is displayed:
Second
Minute
Hour
Day
"Integrator" function: Integration only takes place if the current measured value is
greater than the threshold value. The time base and factor are not included in the
threshold comparison.
-999999999 to 0 to +999999999
The reset signal is used to set the counter and integrator statuses to 0 (inde-
pendently of other parameters). The current status is not saved in the process.
This reset signal is available in addition to the reset signal described in the previous
chapter "General settings".
Digital selector
No selection
period, and day of the week, it is also possible to use individual settings for each
counter/integrator.
Not activated (no checkmark)
Activated (checkmark)
7 Configuration
Description
The measured value is divided by 1 and
added up every second.
The measured value is divided by 60 and
added up every second.
The measured value is divided by 3600
and added up every second.
The measured value is divided by 86400
and added up every second.
Display in seconds
Display in minutes
Display in hours
Display in days
Threshold value
The signal (high active) can be selected
from the list of digital signals.
No signal selected.
The general settings are used.
The individual settings are used (for "Pa-
rameter" and "Selection/settings": see
the previous chapter "General settings").
137

Advertisement

Table of Contents
loading

This manual is also suitable for:

706521

Table of Contents