JUMO LOGOSCREEN 601 Operating Manual page 103

Parameter
Show bar graph
Show text image
Show process
screen
Show reports
Display counters/
integrators
Display batch
Input simulation
?
Show alarms
Barcode -> Batch
mask
Thousand sep-
arator
Lock touchscreen Lock the touchscreen to prevent use. This does not switch off the screen.
Width of auxiliary
line
Image after reset, Image after Home-Button:
Additional settings may be required for a visualization to be displayed by the device. For example, batch-
es can only be displayed if they are appropriately configured by the user.
Input simulation
NOTE!
The inputs and outputs adopt an undefined status. This parameter should only be activated for test pur-
poses and also only if no digital outputs are connected.
Selection/settings
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
Yes, No
No selection
Digital selector
1 to 3
7 Configuration
Description
"Yes" releases the "Bar graph" visualiza-
tion for selection by the user.
"Yes" releases the "Text image" visual-
ization for selection by the user.
"Yes" releases the "Process screen" vi-
sualization for selection by the user.
"Yes" releases the "Reports" visualiza-
tion for selection by the user.
"Yes" releases the "Counters/Integra-
tors" visualization for selection by the us-
er.
"Yes" releases the "Current batch" and
"Completed batch" visualizations for se-
lection by the user.
If "Yes" is selected, all inputs and outputs
of the device are ignored and pseudo
data is displayed on the screen.
"No" suppresses displaying fault and
alarm messages in the status and title
bars.
If "Yes" is selected, the "Current batch"
visualization is automatically shown
when the corresponding barcode is
scanned.
If "Yes" is selected, a stroke will be used
in certain visualizations as an identifica-
tion marking for numbers above and in-
cluding 1000.
Example:
Not locked
Signal (high active) with which the touch-
screen (screen) is locked while the signal
is active.
Width of the auxiliary lines in the curve
diagram
103