JUMO LOGOSCREEN 601 Operating Manual page 106

7 Configuration
Parameter
Resistance mea-
suring range
Measuring range
start
?
Measuring range
end
?
Scaling
start
?
Scale
end
?
Decimal places
Offset
?
Filter time con-
stant
?
Compensation
Ext. reference
temperature
106
Selection/settings
Customer-specific 1 to 4
Measuring range for resistance/potentiometer and for customer-specific lineariza-
tion with RTD temperature probe
0 to 4000 Ω
0 to 400 Ω
-99999 to +99999
(Default setting depends on sensor and
linearization.)
-99999 to +99999
(Default setting depends on sensor and
linearization.)
-99999 to +99999
(Default setting depends on sensor and
linearization.)
-99999 to +99999
(Default setting depends on sensor and
linearization.)
Number of pre-decimal and decimal places for the numerical display of the mea-
sured value
Even if the number of decimal places is fixed, the format is automatically changed
if needed in order to display all digits before the decimal point.
Auto
XXXXXp
XXXXpX
XXXpXX
XXpXXX
XpXXXX
-99999 to 0 to +99999
0 s to 1 s to 100 s
Selection of cold junction (for thermocouple)
Internal Pt100
External constant
-30 to 0 to +85
Description
Customer-specific linearization using
grid points (pairs of values) or 4th order
polynomial
Lower limit of measuring range (for volt-
age/current signal, resistance/potenti-
ometer, or resistance transmitter)
If the measured value is below the lower
limit, "<<<<<" (out of range) is shown for
a numerical display.
Upper limit of measuring range (for volt-
age/current signal, resistor/potentiome-
ter, or resistance transmitter)
If the measured value is above the upper
limit, ">>>>>" (out of range) is shown for
a numerical display.
Lower limit of measuring range or display
range (depending on sensor and linear-
ization)
Upper limit of measuring range or display
range (depending on sensor and linear-
ization)
Automatic
No decimal place
One decimal place
Two decimal places
Three decimal places
Four decimal places
Correction value
Time constant for adjusting the digital in-
put filter (0 s = filter off)
Internal Pt100 temperature probe
Constant cold junction temperature
Cold junction temperature (for thermo-
couple and constant cold junction tem-
perature)