Basic Calibration Procedure - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual

3.3.2. Basic Calibration Procedure

While it is possible to perform the following procedure with any range setting we
recommend that you perform this initial checkout using the 500 ppb range.
The following procedure assumes that the instrument DOES NOT
have any of the available Zero/Span Valve Options installed and
See Section 7 for instructions for calibrating instruments
1. Set the Analog Output Range of the M400E
Press this button to set
the analyzer for SNGL
DUAL or AUTO range
(see Section 6.4)
To change the value of the Range
Setting, enter the number
sequence by pressing the key
under each digit until the expected
value appears.
P/N 04316 Rev: B
Cal gas will be supplied through the Sample port.
See Section 5.3 for information regarding setting up of
Z/S Valve options.
possessing Z/S Valve Options.
SAMPLE
< TST TST > CAL
SETUP X.X
CFG DAS
SETUP X.X
MODE SET UNIT
SETUP X.X
0 0
SETUP X.X
0 0
NOTE
RANGE = 500.0 PPB
RNGE PASS CLK MORE
RANGE CONTROL MENU
RANGE: 500.0 CONC
5 0 0 .0
ENTR EXIT
RANGE: 500.0 Conc
5 0 0 .0 ENTR EXIT
EXIT ignores the new setting and returns to the
ENTR accepts the new setting and returns to the
Getting Started
O3 =
SETUP
EXIT
EXIT
Press this butto n to select
the Measurement Range
unit Type
(see Section 6.4.6)
previous menu.
previous menu..
39