Analog Output Range Selection And Offset Adjustment - Teledyne 400E Instruction Manual

Operating Instructions

6.6.1. Analog Output Range Selection and Offset Adjustment

The final step in configuring the analyzer's three analog output channels is to set
the electronic signal type and range of each channel. This consists of selecting a
type, voltage or current (if an optional current output driver has been installed),
and a signal level that matches the input requirements of the recording device
attached to the channel. A bipolar offset can be also added to the signal if
required.
To select an output signal type (DC Voltage or current) and level for one output
channel, activate the ANALOG I/O CONFIGURATION MENU, then press:
These keys set
the signal level
and type of the
selected channel
84
FROM ANALOG I/O CONFIGURATION MENU
DIAG ANALOG I / O CONFIGURATION
PREV NEXT
DIAG AIO AOUTS CALIBRATED: NO
< SET SET> CAL
DIAG AIO CONC_OUT_2:5V, CAL
< SET SET> EDIT
CONC_OUT_2 RANGE: 5V
DIAG AIO
SET> EDIT
DIAG AIO OUTPUT RANGE: 5V
10V
0.1V 1V 5V CURR
DIAG AIO OUTPUT RANGE: 10V
10V CURR
0.1V 1V 5V
Model 400E Ozone Analyzer
ENTR EXIT
EXIT
EXIT
EXIT
ENTR EXIT
ENTR EXIT
Instruction Manual
Press SET> to select the
analog output channel to be
configured. Press EDIT to
continue
Pressing ENTR records the new setting
and returns to the previous menu.
Pressing EXIT ignores the new setting and
returns to the previous menu.
P/N 04316 Rev: B