Setting The O; Generator Low-Span (Mid Point) Output Level - Teledyne 400E Instruction Manual

Operating Instructions

6.4.2. Setting the O

Level
For applications where To set the ozone LO SPAN (Midpoint) concentration for the
IZS O generator, press:
3
SAMPLE
< TST
SETUP X.X
CFG ACAL
SETUP X.X
COMM
SETUP X.X
8
SETUP X.X
SETUP X.X
SPAN CAL M
0
Toggle these keys to change setting
• Only Values from 0 to 1500 will be accepted..
• A value of 0 turns the lamp OFF.
•
70
Generator Low-Span (Mid Point) Output
3
RANGE = 500.0 PPB
CAL CALZ CALS
DAS RNGE PASS
VARS DIAG O3 HALT
ENTER VARS PASS:818
1 8
0) DAS_HOLD_OFF=15.0 Minutes
NEXT JUMP
Repeat pressing NEXT until ...
3) O3_GEN_LOW1=100.0 PPB
NEXT JUMP
3) O3_GEN_LOW1=100.0 PPB
1 0 0 .0
The ENTR key will disappear if an invalid setting is
attempted.
O3 =XXX.X
SETUP
CLK MORE EXIT
ENTR EXIT
EDIT PRNT EXIT
EDIT PRNT EXIT
ENTR EXIT
Model 400E Ozone Analyzer
Instruction Manual
Sets LOW SPAN Point for
RANGE1.
To Set the LOW SPAN point
for RANGE2 in DUAL or
AUTO range modes ...
Press NEXT key once more
to select O3_GEN_LOW2
then continue as shown.
EXIT ignores the
new setting.
ENTR accepts the
new setting.
P/N 04316 Rev: B