Turning On The Reference Detector Option - Teledyne 400E Instruction Manual

Model 400E Ozone Analyzer
Instruction Manual

6.4.3. Turning on the Reference Detector Option

If the IZS feedback option is purchased the analyzer must be told to accept data
from the Reference Detector and actively adjust the IZS output to maintain the
reference set point(s) previously chosen by the user (see Sections 6.4.1 & 6.4.2).
To perform this operation:
P/N 04316 Rev: B
SAMPLE RANGE = 500.0 PPB
< TST CAL CALZ
SETUP X.X
CFG ACAL DAS RNGE
SETUP X.X
COMM VARS DIAG
O3 CONFIG
SETUP X.X
MODE ADJ DARK
EXIT
SETUP X.X O3 GEN MODE:CNST
CNST REF
• CNST - Constant Mode: In this mode, the analyzer sets the
O Generator drive voltage at a constant level.
3
•
REF - Reference Mode: In this mode, the analyzer uses
feedback from the O
3
Generator Drive Voltage and stabilize the O
Output.
O3 =XXX.XX
CALS
PASS CLK MORE
O3
HALT
ENTR EXIT
Reference Detector to adjust the DO3
Generator
3
Operating Instructions
SETUP
EXIT
EXIT ignores the
new setting.
ENTR accepts the
new setting.
71