Edit A Sequence - NF DP Series Instruction Manual

4. Advanced Operation

4.2.5 Edit a Sequence

-------- Notes ------------------------------------------------------------------------------------------------------------
 A sequence being edited is kept per AC/DC mode. If AC/DC mode is changed, the edited
contents of sequence are loaded based on the change.
 When the power is turned off, edited contents of the sequence are cleared, and all sequences
have the default setting values when it is started next time. To keep the edited contents of
sequence, save them in the Sequence Memory (see 4.2.8).
 When the sequence is loaded from Sequence Memory, the sequence being edited at that time is
discarded.
 You can also turn the output on in the Sequence Edit View. In this case, the output will be set
to the state set in the Step No.0 when the sequence was last compiled (see 4.2.7).
-----------------------------------------------------------------------------------------------------------------------------
 Transit to Sequence Edit View
Press the MENU key to open the root menu, then select [Sequence] (see 3.3.1). While the Sequence
Control View is displayed, if you push the [Edit] soft-key, the execution transitions to the Sequence
Edit View.
94
Sequence
icon
PROGRAMMABLE AC POWER SOURCE