Error Message List; Table 8-2 Error Message List - NF DP Series Instruction Manual

8.1.5 Error Message List

Error messages are listed in Table 8-2.
ID Message
2 Invalid in This Output
Mode
3 Invalid with Output ON
4 Invalid with Output OFF
5 Busy
6 Invalid with Remote
Control
10 Sync Frequency Error
13 Auto Cal Disabled
15 AGC Disabled
20 Invalid
24 USB Memory
Unconnected
25 USB Memory Removed
illegally
26 USB Memory Access
Error
27 Too Many Files
29 Sync Frequency Unlocked
30 Remote Controller Error
31 Internal Memory Error
DP Series/DP Series Type R

Table 8-2 Error Message List

Protection
type
Message This output mode does not allow the setting
display only (execution). Change the output mode.
Message The output on state does not allow the
display only setting (execution). Turn the output off, then
set (execute).
Message The output off state does not allow the
display only setting (execution). Turn the output on, then
set (execute).
Message The busy state does not allow the setting
display only (execution). Execute after the busy icon
disappears.
Message The remote control state does not allow the
display only setting (execution). Bring the state to local
control, then set (execute).
Message The external synchronization signal
display only frequency is out of the range, which does
not allow the setting (execution). Enter the
signal frequency within the range.
Message The Autocal setting becomes off because of
display only out of the calibration range.
Message The AGC setting becomes off because of
display only out of the calibration range.
Message The condition cannot be set (executed).
display only
Message No USB memory is connected. Connect a
display only USB memory.
Message The USB memory was removed before the
display only eject operation. Perform the eject operation
before removing a USB memory.
Message The USB memory has an access error.
display only
Message There are too many files in the USB
display only memory. Each folder can contain 500 files
or less.
Message The output cannot be turned on because of
display only not locking to the synchronization
frequency.
Message Communication with the remote controller
display only cannot be made. Make sure the remote
controller cable is connected properly.
Message The internal memory has an error.
display only
8.1 Error Messages and Error Handling
Cause or Necessary action
251