Polyphase Model - NF DP Series Instruction Manual

2. Preparation before Use

2.5.2 Polyphase Model

 Connection procedure
The figure in the following procedure is the figure when using the cable holder (option). For cable
holder installation, see 7.6.
1. Remove the resin-molded terminal cover and the cable holder (option) of the output terminal.
2. Connect the output terminal to the load with a cable. Connect voltage lines to the L1, L2, and
L3 output terminals of this product. Connect a neutral line to the N terminal of output terminal
of this product, if necessary. Be sure to tighten the screws firmly. In both single-phase
three-wire model and three-phase model, the N terminal can be grounded. If the load has a
ground terminal, connect it to the chassis terminal of the output terminal of this product.
26 PROGRAMMABLE AC POWER SOURCE