Using Monitor Function - NF DP Series Instruction Manual

4. Advanced Operation
-------- Notes ------------------------------------------------------------------------------------------------------------
 We do not guarantee that all USB memories can be operational with this product.
 Use a FAT32-formatted USB memory. This product does not support the exFAT format which
began to be supported from Windows Vista SP1.
 This product does not have the USB memory formatting function.
 The file name should consist of one byte alphanumeric characters. A file name that contains
any double-byte character cannot be recognized correctly.
 This product does not have the time information management function. Therefore, when the
save operation is performed for the USB memory, its time stamp is updated to "2008/1/1
00:00:00."
 Loading by the external control function is not available.
 Limit the number of files to save in one USB memory up to 500 for each of the basic setting,
arbitrary waveform, sequence, and simulation data. If the number of files exceeds this limit,
this product cannot recognize the data files in the USB memory.
 The BACKUP and SYSTEM folders in Figure 4–23 are not used by the users. Do not delete
these folders and files in them, as they are used for firmware updating of this product and other
purposes.
-----------------------------------------------------------------------------------------------------------------------------
 Removing the USB memory from this product (eject operation)
1. Perform the eject operation. Following two methods are available.
(a) Shortcut operation:
(b) Press the MENU key to move to the root menu, then select [System]. In the System menu
that opens, put the cursor on [Exec] next to the [USB Eject] item, then press the ENTER
key.
2. The window opens with the confirmation message "USB Memory Disconnected." The window
closes after a while.
3. Remove the USB memory.
-------- Notes ------------------------------------------------------------------------------------------------------------
 The eject operation cannot be performed in the following cases:
 When the Memory View is open
 When the data list box shows the files in the USB memory
-----------------------------------------------------------------------------------------------------------------------------
4.10

Using Monitor Function

The output voltage and current waveform can be monitored using an oscilloscope connected to the
monitor terminal on the rear. For the monitor output specifications, see 10.24.
170
+
PROGRAMMABLE AC POWER SOURCE