Simulation Memory; Table 4-10 Content Saved In Simulation Memory - NF DP Series Instruction Manual

4. Advanced Operation
 SEQ Recall
In the Memory View, select [SEQ Recall] to change to the Sequence Recall View as below, allowing
you to load the sequence. For the operation method, see 4.2.6.

4.8.4 Simulation Memory

The user-created simulation can be saved in the Simulation Memory.
Both the internal and USB memories can be selected as the Simulation Memory. Creation and
saving of a simulation are performed using the simulation menu (see 4.3) or the control software in
the attached CD-ROM. For the content saved in the Simulation Memory, see Table 4-10.
The internal memory has 5 Simulation Memories from No. 1 to No. 5.
Setting Item
Output range selection
Simulation Function Parameters
 SIM Store
In the Memory View, select [SIM Store] to change to the Simulation Save View as below, allowing
you to save, clear, and rename the simulation. For the operation method, see 4.3.8 and 4.3.9.
168

Table 4-10 Content Saved in Simulation Memory

Factory default setting
100 V
Refer to 4.28
PROGRAMMABLE AC POWER SOURCE