Show Profiles - Axia iQx AES67 Installation & User Manual

Audio Configuration Chapter 3 |
25
Feed to Source Sim Gain (Phone, Codec, Microphone, and Studio Feed Type)
Talkback is sent over dimmed backfeed audio (default of -10dB). If you want a hard interruption (Talkback interrupts
Program audio), set the value to -inf. Adjustment to the attenuation amount is in the range is 0dB to -30dB.
Hybrid for Telos Phone (Phone Type)
This field helps define the Telos VX configuration to interface with. The default of None indicates no interfacing (assume GPIO
control). If interfacing with a Telos VX system, the options to choose are Fixed or Selectable followed by the number of index
value as defined in the VX Studio. Connection to the VX will be defined in the Show Profile section.
Live Controls
The group of radio buttons permits "live" functions for the Options control on each of the console's fader strips. Available
options will vary depending on the source type. One setting may be defined as the Primary or "live" control, which means that
the Options control will vary that setting as soon as you adjust the knob. For example, if PANORAMA has been defined as the
Primary function, simply rotating the Options control will pan the source. The other functions may be enabled or disabled
as desired. Those that are Enabled may be chosen by the operator "on-the-fly" by depressing the Options control. When the
control is pressed, the display will list the options that you've checked as Enabled in this section of the configuration. Pressing
the Options control selects the highlighted option and turning the Options control will adjust the parameter for that option.
Depending on the enabled options, the operator will be able to adjust Source, Gain, Mode, Pan, Dynamics, Equalizer, and
Backfeed.

Show Profiles

Show profiles define how the console is laid out channel by channel and some behavior items, which will be covered in this
section. Access through a link on the left side column, Shows. Pressing this link will change the view to the right of the menu. A
fresh iQx will show four shows that are not defined.
The root page has a few options. The ability to change shows can be done through a GPIO port. The top item allows for defining
a GPIO channel, which would also be applied to a GPIO port of an xNode. Doing so will allow the the GPI triggers to change the
show and likewise create GPO contacts to identify which show is active. GPIO section covers the pin specific information.
Next item is an option to hide the NONE option from the user at the console. The NONE option is a blank show.
The four profiles can be edited, reset, or "Capture" the current console layout and save it as the show profile. Editing the profile
will open a new view with the parameters for the show.