GE Vivid q N Service Manual page 610

GE
D FQ091019, R
IRECTION
Table 8-6
Step
6. Proceed with the Software Installation process by
selecting the following option:
Load Installation
then press <Enter>.
Note: In the event that the Service Tools option had
been selected, you would be prompted for a Password.
This would then provide access to the following:
Check System ID - shows current system version etc.
InitNetwork - (for future use only)
Command Prompt - (for future use only)
7. Select the following option:
Full Clean Install (System + Application +
Documentation)
then press <Enter>.
8. Press [Yes] to continue.
8-104
2
EVISION
Step-by-Step Vivid q N Software Upgrade/Installation/Reinstallation Procedure
Instruction
Section 8-5 - Software Loading
File loading commences. While in progress, the following screen is displayed:
When complete (after approximately 10 minutes), the following message is
displayed prompting you to select the required option:
NEED REPLACEMENT SCREEN CAPTURE
The following Warning message is displayed:
The following message is displayed, providing the option to reboot the system
manually (if preferred) when software installation complete:
V N S
IVID Q
Expected Result
should show Vivid Q System ID
M
ERVICE ANUAL