GE Vivid q N Service Manual page 111

GE
D FQ091019, R
IRECTION
Mini USB Port
3.) Connect the other end of the USB cable to the Vivid q N USB port at the rear of the Vivid q N - see
Figure
4.) Plug the power supply into the mains power supply.
5.) Insert the DVD Patch CD R2423877 into the DVD/CD-RW Drive and follow the on-screen
instructions to load the software patch.
6.) When done, remove the CD from the drive.
7.) Perform the following tests:
a.) Insert a CD-R disk in the DVD/CD-RW Drive.
b.) Eject and remove the CD-R disk to check the eject mechanism functions properly.
NOTE: In the event that problems are experienced when exporting to DVD media, the error message
"Failed to finalize media" is displayed. It is therefore recommended to use the Medical Grade
5V Power Supply
for DVD Samsung Universal (P/N 2421169) and connect it to the peripheral outlet on the
SafeLock Cart, as shown in
Figure 3-32 Samsung DVD/CD-RW Drive Connected through 5V Power Supply
2
EVISION
Figure 3-30 Mini USB Port on Samsung DVD/CD-RW Drive
3-31.
Figure 3-31 USB Ports Located at Rear of the Vivid q N
Figure 3-32
Chapter 3 - System Setup
USB Ports
.
V N S M
IVID Q ERVICE ANUAL
3-39